|


 |
|
If the water
stops draining from the yellow bag, move the mesh around with your
fingers to help the water pass through. After the water is all drained,
repeat the same process as the orange bag (xx).
**CAUTION: Do not
rinse strongly as the bag will fill up with too much water. Use just
enough water to move the product to the center of the mesh.
|
|
NOTES:
1) Rinse and wash your bags with cold water only,
hot water will melt the trichomes to the mesh and cause blockages.
If mesh becomes blocked clean with pure alcohol
2) rinse and wash your bags immediately after using
so that no materials dry and become blocked in the mesh.
3) Rinse the outside of the red into orange bag,
then the orange into the yellow bag to remove any trichomes that may
be stuck to the outer surface.
4) Pouring the water from the bucket through all
three bags again (plant mass included) will yield a little bit more
product. (Not sure if the results justify the time. Judge for yourself).
5) Keeping the water as cold as possible is important,
this allows the trichomes to release from the plant matter.
6) These instructions are not written in stone. If
followed, they will insure good results (also depends on the amount
of trichomes on your plant matter). Feel free to experiment with the
process, any feedback to improve this method would be greatly appreciated.
Enjoy! |
|
| |
|